Completed Guideline How To Verify,Setup And Installation for ENDRESS+HAUSER Ultrasonic Clamp-On Flow Meter

28/07/2016 by Leave a Comment

This post,I would like to share video from ENDRESS+HAUSER about completed guideline how to install Ultrasonic Clamp-On Flow Meter Proline Prosonic start from determine right position to install a sensors,mounting specs and measurement,how to setup and install sensor,cable route and how to do cable termination from transmitter to sensor.

From this video,I hope all of you can get the clear view,how to setup,install and commissioning your Ultrasonic Clamp-On Flow Meter with perfect and right method to ensure this unit working properly without any trouble.ENDRESS+HAUSER always improved their customer service and technical support from time to time to ensure their products can meet customer satisfaction. Read More

Filed Under: Instruments Tagged With: , , , , , , , , , , , , , , , , ,

Pump down method

10/04/2011 by 2 Comments

This method is applied to stored the refrigerant in a system of air-condition into a compressor.The main reason is to avoid a system from lost the refrigerant when perform the maintenance services or to relocated the unit.

We can save a cost for refill a refrigerant and can reduce a air pollution.Why we must throw out the refrigerant if we can stored it.Imagine if the system used a lot of refrigerant but we do not stored it,we waste the gas and cost for refill it back.

That why pump down method is important when we perform a task required to open or dismantle a pipe line of system.All maintenance person or HVAC technician must know how to perform pump down. read more

Filed Under: HVAC Tagged With: , , , , ,