How To Use Bearing Induction Heater ?

01/08/2016 by Leave a Comment

This post I would like to share a video How To Use Bearing Induction Heater.Normally when we dealing with bigger motor or pump bearing,it’s quite difficult to install bearing into shaft because a tolerance gap is small.If we use a bearing pusher to install bigger size bearing into shaft,it’s risky and probably percentage of bearing was damage is high.That why we must use bearing induction heater for more safe and easy bearing installation.

In this video, I used old version of SKF bearing induction heater but still working perfectly without any problem.For latest version and model of Induction Heater from SKF,please visit SKF website  Read More

Filed Under: Do It Your Self Tagged With: , , , , , , , , , , , , , , , , , ,

Completed Guideline How To Verify,Setup And Installation for ENDRESS+HAUSER Ultrasonic Clamp-On Flow Meter

28/07/2016 by Leave a Comment

This post,I would like to share video from ENDRESS+HAUSER about completed guideline how to install Ultrasonic Clamp-On Flow Meter Proline Prosonic start from determine right position to install a sensors,mounting specs and measurement,how to setup and install sensor,cable route and how to do cable termination from transmitter to sensor.

From this video,I hope all of you can get the clear view,how to setup,install and commissioning your Ultrasonic Clamp-On Flow Meter with perfect and right method to ensure this unit working properly without any trouble.ENDRESS+HAUSER always improved their customer service and technical support from time to time to ensure their products can meet customer satisfaction. Read More

Filed Under: Instruments Tagged With: , , , , , , , , , , , , , , , , ,

How To Setup and Programming Endress+Hauser PROSONIC Clamp-On Ultrasonic Flow Meter

27/07/2016 by Leave a Comment

Do you familiar with ENDRESS+HAUSER brand?This time I would like to share about How to setup and programming the PROSONIC Clamp-On Ultrasonic Flow Meter.Also I have attached with video from ENDRESS+HAUSER,method and detail step how to setup the program for PROSONIC Clamp-On Ultrasonic Flow Meter.It very user friendly and easy to setup.

This is basic information about Endress+Hauser Prosonic Clamp-On Ultrasonic Flow Meter :-

The measuring device described in these Operating Instructions is to be used only for measuring the flow rate of liquids in closed pipes.
Examples:
• Acids, alkalis, paints, oils
• Liquid gas
• Ultrapure water with low conductivity, water, wastewater  Read More

Filed Under: Instruments Tagged With: , , , , , , , , , , , , , , , , , ,

Types of electrical conduits

27/10/2011 by 2 Comments

When we plan to do for electrical wiring,we need to use a conduit system to protect an electrical cable from damage due to mechanical or biological.It also make electrical wiring look nice and proper arrangement.

As an electrician,a knowledge about conduits is important to decide which types are suitable for our wiring application and structure.If we choose a wrong types,it can cause the serious damage,increase cost for material and also can reduce wiring life span.

An electrical conduit system is designed for electrical piping system used for wiring installation.It made electrical wiring more easy to installed and have a proper way. Electrical conduit may be made of metal, plastic,fiber, or fired resistance material. read more

Filed Under: Wiring Techniques Tagged With: , , , , , ,