How To Setup and Programming Endress+Hauser PROSONIC Clamp-On Ultrasonic Flow Meter

27/07/2016 by Leave a Comment

Do you familiar with ENDRESS+HAUSER brand?This time I would like to share about How to setup and programming the PROSONIC Clamp-On Ultrasonic Flow Meter.Also I have attached with video from ENDRESS+HAUSER,method and detail step how to setup the program for PROSONIC Clamp-On Ultrasonic Flow Meter.It very user friendly and easy to setup.

This is basic information about Endress+Hauser Prosonic Clamp-On Ultrasonic Flow Meter :-

The measuring device described in these Operating Instructions is to be used only for measuring the flow rate of liquids in closed pipes.
Examples:
• Acids, alkalis, paints, oils
• Liquid gas
• Ultrapure water with low conductivity, water, wastewater  Read More

Filed Under: Instruments Tagged With: , , , , , , , , , , , , , , , , , ,

Temperature winding correction

01/06/2011 by 5 Comments

When we perform insulation resistance tester,temperature winding effected the accuracy of Mega Ohms reading.The basic theory is when temperature increase,the insulation resistance decrease due to physical factor of material for winding.

To get a accurate reading for insulation resistance ( Mega Ohms ),we need to ensure the minimum temperature during measurement.

According to IEEE  43,the temperature correction should be to 40 °C and the correction factor for temperature is such that the minimum insulation resistance value is doubled for every 10 °C decrease in winding temperature. read more

Filed Under: Electric Motor Tagged With: , , , , , ,